Re: [Vserver] interfaces that should appear inside a vserver:
 vserver development mailing list 
[Next/Previous Months] [Main vserver Project Homepage] [Howto Subscribe/Unsubscribe] [Paul Sladen's vserver stuff]
About this list Date view Thread view Subject view Author view Attachment view

From: primero (primero_at_fastwebnet.it)
Date: Fri 04 Feb 2005 - 09:18:51 GMT

Darryl Ross wrote:

> Yes, that is normal, at least in my experience. You will notice if you
> look closer that you can't see the IP address of the actual eth0 device.
>
What you mean with "you can't see" ?

this is my output:

------------------------------------------------------------

Shadow root # vserver template-debian enter
WARNING: can not find configuration, assuming legacy method
ipv4root is now 192.168.101.2
New security context is 3
mesg: /dev/pts/4: Operation not permitted
template-debian:/# ifconfig
eth0 Link encap:Ethernet HWaddr 00:11:2F:A7:B3:87
          inet addr:192.168.101.130 Bcast:192.168.101.63
Mask:255.255.255.192
          inet6 addr: fe80::211:2fff:fea7:b387/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
          RX packets:960550 errors:0 dropped:0 overruns:0 frame:0
          TX packets:696334 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:1112512141 (1.0 GiB) TX bytes:84828908 (80.8 MiB)
          Interrupt:169 Memory:f7d00000-0

eth0:temp Link encap:Ethernet HWaddr 00:11:2F:A7:B3:87
          inet addr:192.168.101.2 Bcast:192.168.101.63
Mask:255.255.255.192
          UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
          Interrupt:169 Memory:f7d00000-0

lo Link encap:Local Loopback
          inet addr:127.0.0.1 Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING MTU:16436 Metric:1
          RX packets:2405 errors:0 dropped:0 overruns:0 frame:0
          TX packets:2405 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:2973599 (2.8 MiB) TX bytes:2973599 (2.8 MiB)

template-debian:/#

-------------------------

As you can check i see both "eth0" and "eth0:template-debian" inside the
vserver ... i was wondering what would happens if i start another one
vserver on a second alias interface ... would i see all the three
interfaces?

btw ... if it sounds normal i'll don't mind too much. :)

> Regards
> Darryl
>
Bye
P.

_______________________________________________
Vserver mailing list
Vserver_at_list.linux-vserver.org
http://list.linux-vserver.org/mailman/listinfo/vserver

About this list Date view Thread view Subject view Author view Attachment view
[Next/Previous Months] [Main vserver Project Homepage] [Howto Subscribe/Unsubscribe] [Paul Sladen's vserver stuff]
Generated on Fri 04 Feb 2005 - 09:15:04 GMT by hypermail 2.1.3