[vserver] some questions of naddress

From: songjun435 <songjun435_at_gmail.com>
Date: Wed 14 Mar 2012 - 13:38:32 GMT
Message-ID: <201203142138277036469@gmail.com>

hi,all:
I use naddress command to add ip to the vps

1. I have started a test vps with "--interface eth0:192.168.155.50/24",and I enter the test vps,execute ifconfig:
eth0 Link encap:Ethernet HWaddr 78:2B:CB:02:2C:18
          inet addr:192.168.155.50 Bcast:192.168.155.255 Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
          RX packets:271309 errors:0 dropped:0 overruns:0 frame:0
          TX packets:58440 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:124534819 (118.7 MiB) TX bytes:5267316 (5.0 MiB)
          Interrupt:98 Memory:d6000000-d6012800

2. then I execute "naddress --set --nid 42 --ip 10.0.0.3/24",information on the console:
Adding 10.0.0.3
3.then I enter the test vps again,and execute ifconfig,
   But now there is nothing output to the console,why?

Can I use the naddress to change the ip of the vps?
And how to give two or more ips to the vps?
Thank you!



3NMedia
Ëξü
Received on Wed Mar 14 13:38:51 2012

[Next/Previous Months] [Main vserver Project Homepage] [Howto Subscribe/Unsubscribe] [Paul Sladen's vserver stuff]
Generated on Wed 14 Mar 2012 - 13:38:52 GMT by hypermail 2.1.8