On Monday 31 October 2005 04:40 pm, Benedikt Boehm wrote:
ahh, ok... hehe the word destroy had me a bit leery to use it :) so then if i
have a mount point already set up, then i can just use the original line with
the destroy parm and it will load it in fine onto the mounted partition.
> On Monday 31 October 2005 19:08, Chuck wrote:
> > this is on a gentoo system.
> > i am trying to create a guest called support. i created the mount point
> > in /vservers, it is mounted and a clear, empty volume. i run this command
> > and get this result:
> > phoenix vservers # vserver-new support --hostname support --context 3920
> > --interface eth3:126.96.36.199/24 template
> > /work/guest-stuff/template.tar.bz2 * Existing vserver installation found.
> > Try --destroy
> vserver-new can handle mount points, just add --destroy and it will
> umount/mount the defice automagically... (you have to specify destroy here,
> because vserver-new can't decide if the mount point is fresh or already
> Vserver mailing list
-- Chuck "...and the hordes of M$*ft users descended upon me in their anger, and asked 'Why do you not get the viruses or the BlueScreensOfDeath or insecure system troubles and slowness or pay through the nose for an OS as *we* do?!!', and I answered...'I use Linux'. " The Book of John, chapter 1, page 1, and end of book _______________________________________________ Vserver mailing list Vserver@list.linux-vserver.org http://list.linux-vserver.org/mailman/listinfo/vserverReceived on Mon Oct 31 23:08:53 2005