[Vserver] routing question

From: Guenther Fuchs <vserver_at_muh.at>
Date: Sat 22 Oct 2005 - 20:46:46 BST
Message-ID: <1158123774.20051022214646@fuchs.info>

Hi there,

have a bit of problem here with setting up the proper routing for a
special environment / requirement:

I've here a dual-homed system which mainly should only be available to
an internal net. Base host therefore hase no external IP (and shall
not), all requests to external shall be routed through an (extra) NAT

So far no problem, setting up all hosts only on eth1 and having a
default gw on the base for this eth1 default route works fine.

Now the prob: There should be set up _one_ host with also internal
_and_ external IP (on eth0) which should externally use a different gw
and also which should not change anything on the base setup. But if I
activate _any_ external IP on eth0 the (previous) default route for
eth1 is nomore used but guests (only having eth1 activated!) try to
connect direct through this eth0 ip which they naturally can't use so
traffic stops completely 8-(

Any idea's/hint's?

Guenther Fuchs
Vserver mailing list
Received on Sat Oct 22 20:47:04 2005
[Next/Previous Months] [Main vserver Project Homepage] [Howto Subscribe/Unsubscribe] [Paul Sladen's vserver stuff]
Generated on Sat 22 Oct 2005 - 20:47:09 BST by hypermail 2.1.8