Re: [Vserver] routing question

From: Chuck <>
Date: Sat 22 Oct 2005 - 22:07:11 BST
Message-Id: <>

On Saturday 22 October 2005 03:46 pm, Guenther Fuchs wrote:

I would thnk you could do this using iproute2 with tables and rulesets

> Hi there,
> have a bit of problem here with setting up the proper routing for a
> special environment / requirement:
> I've here a dual-homed system which mainly should only be available to
> an internal net. Base host therefore hase no external IP (and shall
> not), all requests to external shall be routed through an (extra) NAT
> gateway.
> So far no problem, setting up all hosts only on eth1 and having a
> default gw on the base for this eth1 default route works fine.
> Now the prob: There should be set up _one_ host with also internal
> _and_ external IP (on eth0) which should externally use a different gw
> and also which should not change anything on the base setup. But if I
> activate _any_ external IP on eth0 the (previous) default route for
> eth1 is nomore used but guests (only having eth1 activated!) try to
> connect direct through this eth0 ip which they naturally can't use so
> traffic stops completely 8-(
> Any idea's/hint's?
> --
> regards,
> Guenther Fuchs
> _______________________________________________
> Vserver mailing list

"...and the hordes of M$*ft users descended upon me in their anger,
and asked 'Why do you not get the viruses or the BlueScreensOfDeath
or insecure system troubles and slowness or pay through the nose 
for an OS as *we* do?!!', and I answered...'I use Linux'. "
The Book of John, chapter 1, page 1, and end of book
Vserver mailing list
Received on Sat Oct 22 22:07:39 2005
[Next/Previous Months] [Main vserver Project Homepage] [Howto Subscribe/Unsubscribe] [Paul Sladen's vserver stuff]
Generated on Sat 22 Oct 2005 - 22:07:42 BST by hypermail 2.1.8