On Sat, Oct 22, 2005 at 09:46:46PM +0200, Guenther Fuchs wrote:
> Hi there,
>
> have a bit of problem here with setting up the proper routing for a
> special environment / requirement:
>
> I've here a dual-homed system which mainly should only be available to
> an internal net. Base host therefore hase no external IP (and shall
> not), all requests to external shall be routed through an (extra) NAT
> gateway.
>
> So far no problem, setting up all hosts only on eth1 and having a
> default gw on the base for this eth1 default route works fine.
>
> Now the prob: There should be set up _one_ host with also internal
> _and_ external IP (on eth0) which should externally use a different gw
> and also which should not change anything on the base setup. But if I
> activate _any_ external IP on eth0 the (previous) default route for
> eth1 is nomore used but guests (only having eth1 activated!) try to
> connect direct through this eth0 ip which they naturally can't use so
> traffic stops completely 8-(
>
> Any idea's/hint's?
http://linux-vserver.org/Documentation
(section archived knowledge)
http://archives.linux-vserver.org/200311/0470.html
best,
Herbert
> --
> regards,
>
> Guenther Fuchs
>
> _______________________________________________
> Vserver mailing list
> Vserver@list.linux-vserver.org
> http://list.linux-vserver.org/mailman/listinfo/vserver
_______________________________________________
Vserver mailing list
Vserver@list.linux-vserver.org
http://list.linux-vserver.org/mailman/listinfo/vserver
Received on Sun Oct 23 11:28:43 2005